In simple words, central battery system is
used to save electricity from the emergency light outlets. This system works
like a circuit breaker with the main switchboard being in the center of the
room with multiple exit lights on the exterior. An alarm button is located at
the top of the entrance door. The lamps are set from this switchboard and it
also provides the backup power supply in case of power failure. Every time when
an electrical fault occurs, it would take some time to restore. So it acts as a
battery for saving energy. Central Battery System will automatically turn off
the lights during Power Outage which can be caused by accident or any other
reasons. As you know how much battery capacity does your phone have, you
probably know that it is enough to get an alarm signal with a warning. But if
you don't have enough battery, it becomes difficult to show the Alert Light
without worrying about the remaining charge level.
For installing central battery system, there
are several important things to keep in mind:
As mentioned above, you
should install the AC socket in both the walls and the floor. That's why its
location should be kept in view as well. Remember to install all the bulbs in
the back of all the rooms. When we talk about using solar panels for lighting,
people usually use them in only one place but it can affect another part of the
house too. If there are two bulbs in both sides, then it can affect each
other's performance. It is better to avoid this problem by installing the bulb
in both sides as they will be symmetrical in nature.
If you are planning to build more than just a
few rooms, I suggest installation of such an emergency situation system into
every corner. It's difficult to control the lighting because there are
different situations that can occur at any corner. Suppose you need to use this
system in every corner of a room. Then this system is applicable inside and
outside your house also.
So, here's what you need to take care of while
installing an emergency battery system. Let me explain one thing in detail for
you. You can make the emergency light system completely disabled by discharging
the battery system. In most cases it is not possible due to the limited power.
You can also reduce the current output so that the lighting can be switched off
when no power is available. Also, you can change the light fixtures whenever
necessary. In some other cases, you can add or remove the wall power. Keeps the
electric current low to make the light lights to stay on.
You should try to install the emergency power
system in the center of the room where the window faces the hallway. Or install
it along the ceiling. For changing the color of the light or the brightness of
the bulbs, you can select the appropriate color and shape and choose appropriate
bulbs. Now when you look at a room with such a system installed, it looks
exactly like having a normal candle light. Because it gives the illusion and
makes sure that there is always power in front of everyone. A good design also
helps in bringing the right message to other clients who might think of having these
kinds of systems installed. Even though the installation can sometimes cause
issues, you should try to do it as soon as possible. Once you start doing it,
you can get better results because you'll be able to improve it without
spending much money.
The central battery system
is an essential factor for the safety of the residence as well. Without proper
maintenance, it may create problems and damages to the whole device. There is
also a risk of falling down of the steps or even going over the edge after the
system fails. Therefore, you should check out your local guidelines and rules
thoroughly before investing in any type of emergency system for the future.
These laws also protect the property as well as its owners.
Comments
Post a Comment